Electronics, optics, surface protection and development of low-pollution products. 
 Summary 
 E-MASK R series is the use of its own synthesis technology developed by the adhesive, apply to the processing and transport for LCD polarizers, through bar code or anti-glare treatment of propylene films, polycarbonate films, polyester films and other materials The surface protection. 
 Feature 
 After pasting a small change in adhesion, easy peeling. 
 Have good transparency, the state can check the adhesive paste. 
 Is pressure-sensitive products. Laminated devices can be simply pasted. 
 Use 
 Polarizers and other optical films for surface protection. (Such as LCD factory use) 
 General Characteristics 
 Item Thickness [mm] ※ 1 adhesion [N/20mm] ※ 2 
 E-MASK? R-50EP 0.060 0.10 
 E-MASK? R-100 0.065 0.30 
 E-MASK? R-200 0.065 0.50 
 E-MASK? R-300 0.070 0.80 
 E-MASK? HR-6010 0.063 0.50 
 E-MASK? HR-6030 0.070 0.90 

 [Test method] 
 ※ 1 Nominal thickness. 
 ※ 2 refer to JIS Z-0237 standard (Adherent: stainless steel plate, Tensile speed: 300mm/min, Peeling angle: 180 °). 

 Notes 
 Avoid sunlight and at room temperature and humidity to keep. 
 Paste Do not press too, so paste it after the film from both ends of the tilt. 
 For the processing of oil contaminated adherend when the adhesive paste on the body before the job is full of degreasing treatment. Occur when dealing with inadequate adhesion and adhesive residue and other pollution problems. 
 When machining under severe conditions, please test the product thoroughly beforehand. 
 After peeling the tape surface in the adhesive coating, plating, etching, bonding and other processing, the ingredients of this product will trace the transfer of the adhesive, thereby causing some problems. Before use under actual situations thoroughly. 
 Painted boards, sometimes due to paint spraying conditions and the tape to peel uneasily or peel the paint with the situation. Please evaluate thoroughly before use. 
 For alumite surface treatment board, depending on treatment conditions, sometimes the SPV properties (peeling) will be different. Before use to be fully recognized. 
 Especially for the natural substrate (marble, wood, etc.), please contact our representative in charge of this product. 
 Remove the protective material on the surface after the paint when cleaning the surface of the full study, low-level processing, drying conditions, the adhesion of the paint after the confirmation to be used. 

 The data in this data sheet is derived under certain conditions, determine the value of this product is not guaranteed. 
 This product may appear different conditions of use quality, performance and functionality of the differences in detail, please consult to the company staff. 
 This product may appear different to use the recorded data with different results. In order to more properly and safely use this product, ask the customer to be self-test before use. 
 This product may be no advance notice to stop production or change the specifications. 
 For this article, intellectual property belongs to Nitto Denko Corporation. In the proper use of the designated purpose other than to use this article, please advance to the Company of the department in charge for consultation. Be copied or reproduced without strict